Manual With laser numbering The presence of numbers does not cancel out the assembly instructions.
Recommendations are on the: How It's Made page

Before disassembling the parts, please study the numbers on the polystyrene foam.

The surface area of ​​some parts is too small to accommodate numbers,
so the numbers are indicated with a dotted line on the free area of ​​the polystyrene foam.
These parts must be marked manually.


All mirrored parts are marked with two slashes //

All parts are 2.5D projections.
Therefore, the surface of the part on the top may differ significantly from the bottom.
Pay attention to these details.
This is a cone-shaped piece.
It is larger at the bottom.


That's all there is to the part numbering, now go to the: How It's Made page